You may see a leaking tap in your home from time to time. With regular use, wear and tear are normal even is it is bought from the top plastic tap manufacturers in south India. However, it’s important to fix a leaking tap earlier rather than later. This is because a leaking tap can result in the loss of quite a volume of water.
Since we are facing a lockdown, a plumber may not be available to address the issue. This is why you can learn how to fix a leaking tap easily to repair it yourself from the plastic tap manufacturers in Delhi. Even under normal circumstances, it can be helpful to know these DIY hacks to such basic plumbing issues
Step 1: Preparation
Gather the right tools and perform specific checks.
Normally, you will only require a screwdriver, a drain plug, a wrench, and a small cloth. Some parts may require a replacement, which you can only confirm once you have dismantled the faucet and had a look. However, the first step to studying how to fix a leaking tap is plugging the drain and turning off all the valves for the water supply. This will prevent the water from disrupting the repairs or potentially worsening and will ensure that no screws or parts fall down the drain as you finish your work.
Step 2: Dismantling
This step will differ based on the type of bathroom fixture that you have. You will have to use a wrench, screwdriver, or spanner to twist the faucet’s handle out of place. Many handles include the standard ball faucets, disk faucets, compression faucets, and cartridge faucets. A compression faucet is the most common type of faucet, with a handle that requires you to press down or lift to turn the faucet on or off. Sometimes, the handles rotate back and forth to complete this mechanism instead.
Step 3: Repair
To start repairing the leaking tap, first, undo the screws on the faucet’s handles. You may have to remove the hot and cold hyperboles to find the screws. Once you have removed the handles, place them away and begin to separate the nut. You can find this sitting on top of the washer seat, which is normally built of rubber. Once the nut has been removed, slowly separate the washer seat which is likely to be attached to a screw below.
Once you have removed the washer seat, reinstate it with a new one. You should also ensure that the new piece is the correct size and fit so that it sits properly inside the faucet’s mechanism. You may have to remove the worn-out washer by cutting it with a knife. Applying a lubricant like a grease to the new washer before inserting it can also prove beneficial. This can help to seal the new part in its place and allow the faucet to function more smoothly.
Step 4: Reassembling
Once you have mastered how to stop a leaking tap, you must reassemble the faucet by using a screwdriver and wrench to put everything back in place. Once this is done, turn the water supply back on and slowly open one of the taps. You should refrain from turning it on abruptly to prevent any damage since all the parts have just been reassembled. There shouldn’t be any more leaks, and the water should run more easily than before.
In case your fixed tap continues to leak, you may have to reseat the washer. Simply redo the steps to get it correct.
Whether it’s a leaking shower pipe or leaking faucet, this technique can be used efficiently with tools that are readily available at home. Check out the Pvc Tap Manufacturer and Wholesaler– Artic bath’s range of products for premium bath accessories with a longer lifetime and the best available quality.